Dot1X Timeout Supp-Timeout - Dell 8 Command Reference Manual

17

dot1x timeout supp-timeout

dot1x timeout supp-timeout
Sets the time in seconds that a switch waits for a response to an Extensible Authentication Protocol
(EAP) request frame from the client before resending the request.
Synopsis dot1x timeout supp-timeout seconds
Operands seconds
Defaults The default timeout is 30 seconds.
Command Interface configuration mode
Modes
Description Use this command to specify the EAP response timeout.
Usage There are no usage guidelines for this command.
Guidelines
Examples To set 45 seconds as the switch-to-client retransmission time for the EAP request frame:
See Also none
278
Specifies the number of seconds that the switch waits for a response to the
EAP frame. The range of valid values is 1-65535.
switch(config)#interface extengigabitethernet 0/16
switch(conf-if-te-0/16)#dot1x timeout supp-timeout 40
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01