Sflow Polling-Interval (Global Version) - Dell 8 Command Reference Manual

13

sflow polling-interval (global version)

sflow polling-interval (global version)
Configures the polling interval globally.
Synopsis sflow polling-interval interval value
no sflow polling-interval
Operands interval value
Defaults The default global counter polling interval value is 20 seconds.
Command Global configuration mode
Modes
Description Use this command to configure the polling interval globally. The interval is the maximum number of
seconds between successive samples of counters to be sent to the collector.
Use the no sflow polling interval interval command to return to the default value.
Usage There are no usage guidelines for this command.
Guidelines
Examples To set the polling interval to 135 seconds:
See Also sflow polling interval (interface version)
220
Specifies a value in seconds to set the polling interval. The range of valid
values is 1-65535.
switch(config)#sFlow polling interval 135
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01