Ip Prefix List Commands; Clear Ip Prefix-List - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

When you use the log option, the CP processor logs details about the packets that

match. Depending on how many packets match the log entry and at what rate, the

CP may become busy as it has to log these packets' details.

IP Prefix List Commands

When you create an access-list without any rule and then apply it to an interface, the ACL behavior

reflects implicit permit.

To configure or enable IP prefix lists, use these commands.

Reset the number of times traffic mets the conditions ("hit" counters) of the configured prefix lists.

clear ip prefix-list [prefix-name]

Clears "hit" counters for all prefix lists unless a prefix list is specified.

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.3.7.0

NOTE: When ACL logging and byte counters are configured simultaneously,

byte counters may display an incorrect value. Configure packet counters with

logging instead.

— configures a MAC ACL filter to drop packets.

— configure a MAC ACL filter with a specified sequence number.

(OPTIONAL) Enter the name of the configured prefix list to

clear only counters for that prefix list, up to 140 characters

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Access Control Lists (ACL)