Permit Icmp - Dell S4810 Reference Manual

-- Line card 4 --
L2Acl
Ipv4Acl :
Ipv6Acl :
Ipv4Qos :
L2Qos
Dell#show cam-acl
Related cam-acl
Commands

permit icmp

To allow all or specific internet control message protocol (ICMP) messages, configure a filter.
S4810
Syntax
permit icmp {source address mask | any | host ipv6-address}
{destination address | any | host ipv6-address} [message-type]
[count [byte]] | [log] [monitor]
To remove this filter, you have two choices:
•
•
Parameters
Defaults Not configured.
Command ACCESS-LIST
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.7.0
Version 8.4.2.1
Version 8.2.1.0
910
Current Settings(in block sizes)
: 2
2
4
2
: 3
— configures CAM profiles to support IPv6 ACLs.
Use the no seq sequence-number command if you know the filter's
sequence number.
Use the no permit icmp {source address mask | any | host ipv6-
address} {destination address | any | host ipv6-address}
command.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the E-Series ExaScale.
IPv6 Access Control Lists (IPv6 ACLs)