Clear Ip Route - Dell S4810 Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4(0.0)
Version 9.0.2.0
Version 9.0.0.0
Version 8.3.7.0
Version
8.3.19.0
Usage To clear Layer 3 CAM inconsistencies, use this command.
Information
Related show ip fib stack-unit
Commands

clear ip route

Clear one or all routes in the routing table.
S4810
Syntax
clear ip route [vrf vrf-name] {* | ip-address mask}
Parameters
vrf vrf-name
*
ip-address
mask
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Version 9.0.2.0
IPv4 Routing
Added support for VRF.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S4820T.
CAUTION: Executing this command causes traffic disruption.
— shows FIB entries on a specified stack-unit.
(Optional) Enter the keyword vrf and then the name of the
VRF to clear the routes corresponding to that VRF.
Enter an asterisk (*) to clear all learned IP routes.
Enter a specific IP address and mask in dotted decimal
format to clear that IP address from the routing table.
Added support for VRF.
Introduced on the S6000.
839