Show Stack-Unit Stack-Ports Ets Details - Dell S4810 Reference Manual

Version
8.3.16.0
Example
Del#show qos priority-groups
(Summary)
priority-group ipc

show stack-unit stack-ports ets details

Displays the ETS configuration applied to egress traffic on stacked ports, including ETS Operational mode
on each unit and the configurated priority groups with dot1p priorities, bandwidth allocation, and
scheduler type.
S4810
Syntax
show stack-unit {all | stack-unit} stack-ports {all | port-
number} ets details
Parameters
stack-unit
port-number
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0
Example
Dell(conf)# show stack-unit all stack-ports all ets details
(Summary)
Stack unit 0 stack port all
Max Supported TC Groups is 4
Number of Traffic Classes is 1
Admin mode is on
Admin Parameters:
--------------------
Admin is enabled
TC-grp Priority#
------------------------------------------------
0
1
2
3
552
Introduced on the MXL 10/40GbE Switch IO Module.
priority-list 4
set-pgid 2
Enter the stack unit identification.
Enter the port number.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
0,1,2,3,4,5,6,7
Bandwidth TSA
100% ETS
- -
- -
- -
Data Center Bridging (DCB)