Ip Route - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

Version 7.6.1.0

Version 7.5.1.0

show ip interface

ip route

Assign a static route to the switch.

ip route [vrf vrf-name] ip-address mask {ip-address | interface

[ip-address]} [distance] [permanent] [tag tag-value] [vrf vrf-

To delete a specific static route, use the no ip route destination mask

To delete all routes matching a certain route, use the no ip route

destination mask command.

vrf vrf-name

interface ip-

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.

— displays the interface routing status and configuration.

(Optoinal) Enter the keyword vrf and then the name of the

VRF to configure a static route corresponding to that VRF.

Use this VRF option after the ip route keyword to

configure a static route on that particular VRF.

Enter the IP address in dotted decimal format of the

destination device.

Enter the mask in the slash prefix format (/x) of the

destination IP address.

Enter the IP address of the forwarding router in dotted

decimal format.

Enter the keyword interface then the IP address.

(OPTIONAL) Enter the value of the distance metric assigned

to the route. The range is from 1 to 255.

(OPTIONAL) Enter the keyword permanent to specify that

the route must not be removed even if the interface assigned

to that route goes down. The route must be currently active

to be installed in the routing table. If you disable the

interface, the route is removed from the routing table.

IPv4 Routing