Ip Domain-Name - Dell S4810 Reference Manual

Version 7.5.1.0
Usage
To fully enable DNS, also specify one or more domain name servers with the ip
Information
name-server command.
Dell Networking OS does not support sending DNS queries over a VLAN. DNS
queries are sent out all other interfaces, including the Management port.
To view current bindings, use the show hosts command.
Related
ip name-server
Commands
show hosts

ip domain-name

Configure one domain name for the switch.
S4810
Syntax
ip domain-name name
To remove the domain name, use the no ip domain-name command.
Parameters
name
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
852
Introduced on the C-Series.
— specifies a DNS server.
— Views the current bindings.
Enter one domain name to be used to complete unqualified
names (that is, incomplete domain names that cannot be
resolved).
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
IPv4 Routing