Show Qos Dcb-Map - Dell S4810 Reference Manual

Usage The dcb-map stack-unit all stack-ports all command overwrites any
Information
previous DCB maps applied to stack ports.

show qos dcb-map

Display the DCB parameters configured in a specified DCB map.
S4810
Syntax
show qos dcb-map map-name
Parameters
map-name
Command
•
Modes
•
Command
Version 9.3(0.0)
History
Version 9.3(0.0)
Usage
Use the show qos dcb-map command to display the enhanced transmission
Information
selection (ETS) and priority-based flow control (PFC) parameters used to configure
server-facing Ethernet ports. S5000 Ethernet ports are DCBx-enabled by default.
The following table describes the show qos dcb-map output shown in the
example below.
Field
State
PFC Mode
PG
TSA
BW
PFC
Priorities
572
Displays the PFC and ETS parameters configured in the
specified map.
EXEC
EXEC Privilege
Introduced on the S4810 and S6000 platforms.
Introduced on the FC Flex IO module installed in the MXL
10/40GbE Switch.
Description
Complete: All mandatory DCB parameters are correctly
configured. In progress: The DCB map configuration is not
complete. Some mandatory parameters are not configured.
PFC configuration in DCB map: On (enabled) or Off.
Priority group configured in the DCB map.
Transmission scheduling algorithm used by the priority
group: Enhanced Transmission Selection (ETS).
Percentage of bandwidth allocated to the priority group.
PFC setting for the priority group: On (enabled) or Off.
802.1p priorities configured in the priority group.
Data Center Bridging (DCB)