Dcb-Enable; Dcb-Output - Dell S4810 Reference Manual

dcb-enable

Enable data center bridging.
S4810
Syntax
dcb enable[pfc-queues 1|4]
To disable DCB, use the no dcb enable command.
Parameters
pfc-queues
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0
Usage
By default, iSCSI is enabled on the unit and flow control is enabled on all of the
Information
interfaces or if link-level flow control is enabled on one or more interfaces. To
enable DCB, do one of the following:
•
•
Related dcb-policy input
Commands ingress interface.

dcb-output

To associate an ETS configuration with priority traffic, create a DCB output policy.
S4810
Syntax
dcb-output policy-name
Data Center Bridging (DCB)
Enter the pfc-queue range. To disable DCB, use the no dcb
enable command. The range is from 1 or 2.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Apply the dcb-input policy command with the no pfc-mode command on
to all the interfaces.
Disable flow-control on all of the interfaces.
— applies the input policy with the PFC configuration to an
535