Remote Programming And Disa Codes; Remote Programming Id Code - Panasonic DBS 824 Installation Manual

FFl Remote Programming ID Code
Remote Programming and DISA Codes
Remote Programming ID Code
Software Version: CPC-S and CPC-M, Version 1 .O and higher
Address: FFl 4## (0000-9999)#
Description The Remote Programming ID Code allows you to enter the terminal
programming mode. This programming mode is used to enter programming
commands from a remote PC or a local PC connected directly to the SMDR
port (CN 1).
You can enter the remote programming mode through any of these three
methods:
l
By dialing into the system through a direct DISA trunk
l
By dialing into the system through a regular CO trunk, then requesting the
operator to enter
the Remote Programming ID Code
l
By using a local
PC
and communications package to connect directly to
the
DBS serial port.
For more information on the
terminal programming mode, see Appendix B.
Programming
To set the remote programming ID code . . .
.
To reset the ID code to the default (9999)...
I
FFl 4## CONF ON/OFF
1
I
1
Issued 3/l /95 DBS 824-l O-400 1-117