Panasonic DBS 824 Installation Manual page 408

Appendix B. Terminal Programming
The body of this Section 400 is devoted to programming the DBS 824 system
through a key phone. However, the DBS 824 can also be programmed
remotely via the Terminal Programming mode. Using this method,
commands can be entered on a remote PC or terminal and sent to the system
via modem; or a local PC or terminal can be connected directly to the DBS
824's Maintenance port (CN2) on the Serial Interface Unit.
You can enter the Terminal Programming mode using any of the following
three methods:
l
Direct Connection: Use a local PC or terminal and a communications
package to connect directly to the DBS 824 serial port.
l
DISA: Dial into the system through a DISA trunk.
l
Operator Transfer: Dial into the system through a regular trunk, then
have the operator enter the Remote Programming ID Code.
This appendix gives an overview of these programming methods.
Terminal Programming Through a Direct Connection
To program the system through a PC or terminal connected to the DBS 824's
CN2 serial port:
1. Make certain the cables are configured and connected as described in
Section 300~Installation.
2. Make certain the DBS 824 is in the Maintenance mode. Dial the following
codes from the attendant port:
ON/OFF ##93
3. Enter your terminal communications program and make sure your PC or
terminal's data communications settings match those of the DBS 824.
4. From your terminal communications program (terminal emulation in a PC
communications package), type the following command:
#99 xxxx (where "xxxx" is the site's password; system default is "9999")
5. After the DBS 824 displays the "Remote Programming" banner screen on
the computer, type P then press ENTER.
6. Follow the directions on the screen to access the desired program.
Issued 3/l/95
DBS 824-10-400