Offhook Signal (Co) - Panasonic DBS 824 Installation Manual

Offhook Signal (CO) FF3
Offhook Signal (CO)
Software Version: CPCS and CPC-M, Version 1 .O and higher
Address: FF3 (ExtPort)# 7# (0 or l)#
Description
This program determines if the DBS 824 system sends a tone signal to busy
extensions when an additional trunk call arrives.
Programming
To activate the Offhook Signal . . .
FF3 (l-l 6 or l-24)# 7# (0 or l)#
f
f
Extension Port:
o=Off
CPC-S: 1-16
l=On
CPC-M: l-24
Note: Default for the primary
attendant is 1 (on).
To reset the Offhook
Signal
to the default value . . .
I
FF3 (l-16 or l-24)# 7# CONF ON/OFF
I
Related Programming .
Offhook Signal Volume: FF3 (ExtPort)# 15# (0-4)#
Offhook Signal Pattern: FF3 (ExtPort)# 16# (0 or l)#
Notes
.
Conditions Under Which the Signal Is Not Se& The system does not send
the offhook signal during a conference call, while the called extension is on
hold, or during a call on a trunk for which there is no line key on the
telephone.
VAU Interaction. If a Voice Announce Unit (VAU) is connected to the DBS
824, ofiook signalling must be enabled on all extensions.
3-10
DBS 824-l O-400
issued 3/l 195