Pooled Trunk Access For Group "9 - Panasonic DBS 824 Installation Manual

FF2
Pooled Trunk Access for Group "9"
Pooled Trunk Access for Group "9"
Software Version: CPGS and CPC-M, Version 1.0 and higher
Address: FF2 (Trunk)## 3# (0 or l)##
Description
Use this feature to place a trunk in a group from which aunks are
automatically chosen for outbound dialing. When you dial "9" from an SLT
or digital extension, or press an PI? key that is set as a pooled mmk key, any
available trunk in the group will be accessed.
The uunk selection is made from the highest trunk number in the group to the
lowest.
Programming
FF2 (l-6 or 1-6)# 3# (0 or l)#
i'
t
Trunk Number:
O=Tmnk is not included in access group "9".
CPC-S:
1-6 l=Trunk
is included in access group 9".
UC-M: l-8
Notes
Zntertrctiun 14% LCR.
Set the "LCR Access" option (address PP12# l# 3#)
so that dialing "9" indicates a Pooled Trunk call. If this option is set so that
dialing u9" indicates an LCR call, trunk selection will default to pooled trunk
line access group 9 if all lines that could be used for LCR access are busy.
Required Zhiwm Setting.
To use pooled trunks, Strap J3 on-the CPC card
must be cut See Section
300~ImMafiun
for
instructions.
Issued 3/l/95
DBS 824-l O-400
2-5