Co Busy Tone Detection - Panasonic DBS 824 Installation Manual

FF2
CO Busy Tone Detection
CO Busy Tone Detection
Software Version: CPC-S and CPC-M, Version 1 .O and higher
Address: FF2 (Trunk)# 22# (0 or l)#
Description
This address determines whether the DBS 824 system will look for a busy
tone from the CO for outgoing calls, for the purpose of activating the Auto-
Repeat Dial feature.
When this programming address is set to "on", the DBS 824 will monitor
hunks for busy tone signals from the CO after outgoing calls are placed; if the
busy tone occurs, the DBS 824 will automatically send a hookflash signal to
the CO and redialthe number while the caller remains off-hook.
Programming
FF2 (1-6 or l-8)# 22# (0 or l)#
f
t
Trunk Number: O=BT detection off.
CPC-S: l-6
l=BT detection on.
CPC-M: 1-8
.
Related Programming
Auto-Repeat Dialing Count: FFl 2# l# 34# (0-15)#
Wait Time for Auto-Repeat Dialing: FFl 3# 26#I (0- 15)##
Busy Tone (BT) Detection Timer: FFl 3# 27# (0- lS)#
Dial Tone (DT) Detection Timer: FFl 3# 28# (0-255)#
Notes
Termination of the Auto-Repeat Dialing Feature. The DBS 824 will
terminate the Auto-Repeat Dialing operation if one of the following occurs:
,
.
Voice (or anything other than BT detection or time-out of the Auto-
Repeat Dialing Wait Time) is detected on the called-party end of
the outgoing call.
.
Caller goes on-hook.
l
RLS key is pressed.
.
The trunk line is seized by another operation (e.g., CO key or MC0
key).
.
Other FF keys are pressed.
Issued 3/l/95
DBS 824-10-400
2-19