Defining User Data - Siemens sinumerik 840d Programming Manual

08.97
3
840D 840D
NCU 571 NCU 572
NCU 573
3.4

Defining user data

Function
Definition of user data (GUD) implemented during
start-up procedure.
The necessary machine data should be initialized
accordingly.
The user memory must be configured, the
necessary memory configuration must be defined in
file %_N_INITIAL_INI which is loaded after the
definition file. All relevant machine data have as a
component of their name GUD.
• SW 5 and higher (01.99):
The user data (GUD) can be defined in the
Services operating area. This means that lengthy
reimport of data backup (%_N_INITIAL_INI) is
not necessary.
The following applies:
• Definition files that are on the hard disk are
not active.
• Definition files that are on the NC are always
active.
Reserved block names
The following modules can be stored in the directory
/_N_DEF_DIR:
_N_SMAC_DEF
_N_MMAC_DEF
_N_UMAC_DEF
_N_SGUD_DEF
_N_MGUD_DEF
_N_UGUD_DEF
_N_GUD4_DEF
_N_GUD5_DEF
_N_GUD6_DEF
_N_GUD7_DEF
_N_GUD8_DEF
_N_GUD9_DEF
Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) − 04.00 Edition
FM-NC 810D 840Di
Contains macro definitions (Siemens, protection level 0)
Contains macro definitions (machine manufacturer, protection level 2)
Contains macro definitions (user, protection level 3)
Contains definitions for global data (Siemens, protection level 0)
Contains definitions for global data (machine manufacturer, protection level 2)
Contains definitions for global data (user, protection level 3)
Freely definable
Contains definitions for measuring cycles (Siemens, protection level 0)
Contains definitions for measuring cycles (Siemens, protection level 0)
Contains definitions for standard cycles (Siemens, protection level 0)
or freely definable without standard cycles
Freely definable
Freely definable
File and Program Management

3.4 Defining user data

3
3-131