Siemens sinumerik 840d Programming Manual page 515

04.00
15
Identifier Type
$TC_DP4 REAL
REAL
$TC_DP5
REAL
$TC_DP6
$TC_DP7 REAL
$TC_DP8 REAL
$TC_DP9 REAL
 Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
Description: System variable/value range/index
$TC_DP4[t,d]
Geometry – Length 2
With active 'Flat D number management' function, the syntax is as
follows:
$TC_DP4[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
$TC_DP5[t,d]
Geometry – Length 3
With active 'Flat D number management' function, the syntax is as
follows:
$TC_DP5[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
$TC_DP6[t,d]
Geometry – Radius
With active 'Flat D number management' function, the syntax is as
follows:
$TC_DP6[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
$TC_DP7[t,d]
Slotting saw: Corner radius
With active 'Flat D number management' function, the syntax is as
follows:
$TC_DP7[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
$TC_DP8[t,d]
Slotting saw: Length
With active 'Flat D number management' function, the syntax is as
follows:
$TC_DP8[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
$TC_DP9[t,d]
Reserved
With active 'Flat D number management' function, the syntax is as
follows:
$TC_DP9[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
15.2 List of system variables
Part pro
R
R
R
R
R
R
Tables
15
Sync O S
W 2
W 2
W 2
W 2
W 2
W 2
15-515