Synchronized Spindle - Siemens sinumerik 840d Programming Manual

12.98
13
840D 840D
NCU 571 NCU 572
NCU 573
13.3

Synchronized spindle

Programming
COUPDEF (FS,LS,SR
COUPDEL (FS,LS)
COUPRES (FS,LS)
COUPON (FS,LS,PS
COUPOF (FS,LS,POS
WAITC (FS, block change beh., FS, block change beh.)
Explanation of the commands
COUPDEF
COUPON
COUPOF
COUPRES
COUPDEL
WAITC
Explanation of the parameters
FS, LS
SR , SR
FS LS
Block change
behavior:
• "NOC"
• "FINE"
• "COARSE"
• "IPOSTOP"
Coupling
• "DV"
• "AV"
PS
FS
POS , POS
FS LS
 Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
840Di
,SR , block change beh., coupling)
FS LS
)
FS
,POS )
FS LS
Define/change user coupling
Activate coupling
Deactivate coupling
Reset coupling parameters
Delete user-defined coupling
Wait for synchronism condition
Name of following and leading spindle; specified with spindle number:
e.g. S2
Speed ratio parameter for following spindle and leading spindle
Default setting = 1.0; specification of denominator optional
Block change method; Block change is implemented by:
Immediate (default)
in response to "Synchronization run fine"
in response to "Synchronization run coarse"
in response to IPOSTOP (i.e. after setpoint synchronization run)
Coupling type: Coupling between FS and LS
Setpoint coupling (default)
Actual-value coupling
Angle offset between leading and following spindles
Deactivation positions of following and leading spindles
Additional Functions
13.3 Synchronized spindle
13
13-431