Siemens sinumerik 840d Programming Manual page 186

Special Motion Commands
5
5.7 Extended measuring function MEASA, MEAWA, MEAC
840D 840D
NCU 571 NCU 572
NCU 573
The following programming errors are detected and indicated
appropriately:
• MEASA/MEAWA is programmed with MEAS/MEAW in the same
block
Example:
N01 MEAS=1 MEASA[X]=(1,1) G01 F100 POS[X]=100
• MEASA/MEAWA with number of parameters <2 or >5
Example:
N01 MEAWA[X]=(1) G01 F100 POS[X]=100
• MEASA/MEAWA with trigger event not equal to 1/ –1/ 2/ –2
Example:
N01 MEASA[B]=(1,1,3) B100
• MEASA/MEAWA with invalid mode
Example:
N01 MEAWA[B]=(4,1) B100
• MEASA/MEAWA with trigger event programmed twice
Example:
N01 MEASA[B]=(1,1,-1,2,-1) B100
• MEASA/MEAWA and missing GEO axis
Example:
N01 MEASA[X]=(1,1) MEASA[Y]=(1,1) G01 X50 Y50 Z50 F100
• Inconsistent measuring job with GEO axes
Example:
N01 MEASA[X]=(1,1) MEASA[Y]=(1,1) MEASA[Z]=(1,1,2) G01
X50 Y50 Z50 F100
5-186
810D 840Di
CCU 2
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) − 04.00 Edition
04.00
5
GEO axis X/Y/Z
 Siemens AG 2000. All rights reserved