Mitsubishi Electric melsec q00ujcpu User Manual page 323

(2) PLC system
Parameters required for use of the CPU module are set.
Parameter
Item
Low speed
Timer limit
setting
High speed
RUN
RUN-
PAUSE
PAUSE
contcts
Latch data backup
operation valid contact
Remote reset
Output mode at STOP to
RUN
Intelligent function module
setting (Interrupt pointer 100A
setting)
Module synchronization 100C
8 - 3
Figure 8.2 PLC system
Table8.2 PLC system setting list
Description
No.
Set the time limit for the low
1000
H
speed timer or high speed timer.
Set the contacts that control RUN/
PAUSE of the CPU module.
1001
H
Setting of only the PAUSE contact
is not allowed.
Set the valid contact device No.
1014 for backup of latch data to the
H
standard ROM.
Select whether to allow the
1002
H
remote reset from GX Developer.
Set the status of the outputs (Y)
1003 when the operating status is
H
switched from STOP to RUN.
Assign the interrupt pointers (I50
to I255) and set the start I/O
H
number and start SI number of
each intelligent function module.
Select whether to synchronize
CPU module startup with
H
intelligent function module
startup.
Setting range
1ms to 1000ms (in increments of 1ms)
0.01ms to 100.0ms (in increments of
0.01ms)
X0 to 1FFF
X, M, B
Selected/deselected
Previous state, Recalculate (output is 1
scan later)
• Start I/O No.
• Start SI No.
• I50 to 255
Selected/deselected
Default Reference
100ms Section 9.2.10
10.0ms Section 9.2.10
Section 6.6.1
Blank
Section 6.6.2
Blank Section 6.28
Deselected Section 6.6.3
Previous state Section 6.4
Blank Section 9.11
Deselected
-
(To the next page)