Table of Contents
Advertisement
11.4
Procedure for Writing Multiple Programs
This section describes a procedure for writing multiple programs to the program memory. (
5.1.2)
Follow the procedure below and then the procedure provided in Section 11.5 before storing the programs
in the memory card for boot operation.
In the following procedure,
NO
Change the number of device points in the
Device tab of the PLC parameter dialog box.
Create programs to be executed in the
CPU module.
NO
Set the initial device value range.
Set a file name for initial device value in the
PLC file tab of the PLC parameter dialog box.
11 - 7
indicates an operation on the CPU module side.
Start
Start GX Developer.
Set the project.
Change the number of
device points?
YES
Use the initial device value?
YES
Set the device memory.
1)
GX Developer Version 8 Operating Manual
Section 9.2
Ladder (writing) screen
Section 6.25
Section 6.25
Section 6.25
Section
Advertisement
Table of Contents
