Table of Contents
Advertisement
Creating PVLAN ports
PVLAN ports are those that will be assigned to the PVLAN.
1
Access INTERFACE mode for the port that you want to assign to a PVLAN.
CONFIGURATION mode
interface interface
2
Enable the port.
INTERFACE mode
no shutdown
3
Set the port in Layer 2 mode.
INTERFACE mode
switchport
4
Select the PVLAN mode.
INTERFACE mode
switchport mode private-vlan {host | promiscuous | trunk}
•
host (isolated or community VLAN port)
•
promiscuous (intra-VLAN communication port)
•
trunk (inter-switch PVLAN hub port)
Example of the switchport mode private-vlan Command
For interface details, refer to
NOTE:
You cannot add interfaces that are configured as PVLAN ports to regular VLANs. Conversely, you
cannot add "regular" ports (ports not configured as PVLAN ports) to PVLANs.
The example below shows the switchport mode private-vlan command on a port and on a port
channel.
Dell#conf
Dell(conf)#interface TengigabitEthernet 2/1
Dell(conf-if-te-2/1)#switchport mode private-vlan promiscuous
Dell(conf)#interface TengigabitEthernet 2/2
Dell(conf-if-te-2/2)#switchport mode private-vlan host
Dell(conf)#interface TengigabitEthernet 2/3
Dell(conf-if-te-2/3)#switchport mode private-vlan trunk
Dell(conf)#interface TengigabitEthernet 2/2
Dell(conf-if-te-2/2)#switchport mode private-vlan host
Dell(conf)#interface port-channel 10
Dell(conf-if-po-10)#switchport mode private-vlan promiscuous
Enabling a Physical Interface
in the
Interfaces
chapter.
Private VLANs (PVLAN)
898
Advertisement
Table of Contents
Troubleshooting
