Configuring IGMP Snooping
Configuring IGMP snooping is a one-step process. To enable, view, or disable IGMP snooping, use the
following commands.
There is no specific configuration needed for IGMP snooping with virtual link trunking (VLT). For information
about VLT configurations, refer to
•
Enable IGMP snooping on a switch.
CONFIGURATION mode
ip igmp snooping enable
•
View the configuration.
CONFIGURATION mode
show running-config
•
Disable snooping on a VLAN.
INTERFACE VLAN mode
no ip igmp snooping
Related Configuration Tasks
•
Specifying a Port as Connected to a Multicast Router
•
Removing a Group-Port Association
•
Disabling Multicast Flooding
•
Configuring the Switch as Querier
Example of ip igmp snooping enable Command
Dell(conf)#ip igmp snooping enable
Dell(conf)#do show running-config igmp
ip igmp snooping enable
Dell(conf)#
Removing a Group-Port Association
To configure or view the remove a group-port association feature, use the following commands.
•
Configure the switch to remove a group-port association after receiving an IGMP Leave message.
INTERFACE VLAN mode
ip igmp fast-leave
•
View the configuration.
INTERFACE VLAN mode
show config
Example of Configuration Output After Removing a Group-Port Association
Dell(conf-if-vl-100)#show config
!
Virtual Link Trunking
(VLT).
Internet Group Management Protocol (IGMP)
486