Table of Contents
Advertisement
The power inline command has the following parameters:
•
max_milliwatts — (OPTIONAL) Specify the maximum inline power that is allocated to a powered
device connected to the interface. The range if from 440 to 30000 mW. When you do not configure a
power value, the system uses the default value (30000 mW).
NOTE:
The max_milliwatts option only works when you use Static Management mode. When
you enable Class mode, the max_milliwatts option has no effect on the interface. For
information about Class Power Management mode, see
Configuring Power Management Mode - Class and Static
•
priority — Enter the keyword priority to configure the powered device to connect to the
interface.
•
critical — Enter the keyword critical to set the PoE priority level as critical.
•
high — Enter the keyword high to set the PoE priority level as high.
•
low — Enter the keyword low to set the PoE priority level as low. By default, all ports are set to low
priority.
•
Configure the maximum power allocation and priority for the powered device connected to a port
extender interface.
Interface Mode
power inline {[max_milliwatts] | priority {critical | high | low}}
The following example sets the maximum allocated power to interface peGigE 255/0/1 3000 mW.
Example of Setting the Maximum Allocated Power to an Interface
Dell(conf)#interface peGigE ?
PE-ID/UNIT/PORT
Dell(conf)#int peGigE 0/0/1
Dell(conf-if-pegi-255/0/1)#power inline ?
<440-30000>
priority
Dell(conf-if-pegi-0/0/1)#power inline 30000
Example of Setting the Priority to Critical
The following example sets the priority on interface peGigE 255/0/1 to critical.
Dell(conf-if-pegi-255/0/1)#power inline
Dell(conf-if-pegi-255/0/1)#power inline priority ?
critical
high
low
Dell(conf-if-pegi-0/0/1)#power inline priority critical
Example of Displaying PoE Power Allocation on a Port Extender
The following example displays the PoE power allocation to power devices by the port extender, using the
show power inline {pe pe—id stack-unit unit-number | interface interface} command.
For a description of the fields, see
power consumption on a port extender, see
Dell#show power inline pe 255 stack-unit 0
Global inline power Threshold :
PE Gigabit Ethernet interface number
Max milliwatts (default = 30000)
Configure poe priority
Critical priority
High priority
Low priority (default)
Displaying PoE Power
Displaying Power Consumption on the Port Extender.
Mode.
Allocation. For information about displaying inline
99
Power over Ethernet (PoE)
878
Advertisement
Table of Contents
Troubleshooting
