Important Points About Shared Lag State Tracking; Lacp Basic Configuration Example - Dell C9000 Series Networking Configuration Manual

Hide thumbs Also See for C9000 Series:

Table of Contents

Last clearing of "show interface" counters 00:01:28

Queueing strategy: fifo

The set of console messages shown above appear only if you configure shared LAG state tracking

on that router (you can configure the feature on one or both sides of a link). For example, as previously

shown, if you configured shared LAG state tracking on R2 only, no messages appear on R4 regarding the

state of LAGs in a failover group.

Important Points about Shared LAG State

The following is more information about shared LAG state tracking.

This feature is available for static and dynamic LAGs.

Only a LAG can be a member of a failover group.

You can configure shared LAG state tracking on one side of a link or on both sides.

If a LAG that is part of a failover group is deleted, the failover group is deleted.

If a LAG moves to the Down state due to this feature, its members may still be in the Up state.

The screenshots in this section are based on the following example topology. Two routers are named ALPHA

and BRAVO, and their hostname prompts reflect those names.

Figure 62. LACP Basic Configuration Example

Link Aggregation Control Protocol (LACP)

Troubleshooting