Dell C9000 Series Networking Configuration Manual page 949

> - non-active route, + - summary route
Gateway of last resort is not set
Destination Gateway
----------- ------- ----------- -----------
C 10.11.10.0/24
C 10.11.20.0/24
R 10.11.30.0/24
C 10.200.10.0/24
C 10.300.10.0/24
R 192.168.1.0/24
R 192.168.2.0/24
Core2#
R 192.168.1.0/24
R 192.168.2.0/24
Core2#
To view the RIP configuration activity on Core 2, use the show ip protocols command.
Core2#show ip protocols
Routing Protocol is "RIP"
Sending updates every 30 seconds, next due in 17
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is 1
Default version control: receive version 2, send version 2
Interface Recv Send
TenGigabitEthernet 2/42 2 2
TenGigabitEthernet 2/41 2 2
TenGigabitEthernet 2/31 2 2
TenGigabitEthernet 2/11 2 2
Routing for Networks:
10.300.10.0
10.200.10.0
10.11.20.0
10.11.10.0
Routing Information Sources:
Gateway Distance
10.11.20.1 120
Distance: (default is 120)
Core2#
RIP Configuration on Core3
The following example shows how to configure RIPv2 on a host named Core3.
Example of Configuring RIPv2 on Core3
Core3(conf-if-te-3/21)#router rip
Core3(conf-router_rip)#version 2
Core3(conf-router_rip)#network 192.168.1.0
Core3(conf-router_rip)#network 192.168.2.0
Core3(conf-router_rip)#network 10.11.30.0
Core3(conf-router_rip)#network 10.11.20.0
Core3(conf-router_rip)#show config
!
Dist/Metric Last Change
Direct, Te 2/11
Direct, Te 2/31
via 10.11.20.1, Te 2/31
Direct, Te 2/41
Direct, Te 2/42
via 10.11.20.1, Te 2/31
via 10.11.20.1, Te 2/31
via 10.11.20.1, Te 2/31
via 10.11.20.1, Te 2/31
Last Update
00:00:12
0/0 00:02:26
0/0 00:02:02
120/1 00:01:20
0/0 00:03:03
0/0 00:02:42
120/1 00:01:20
120/1 00:01:20
120/1 00:05:22
120/1 00:05:22
Routing Information Protocol (RIP) 949