Supported Features - Dell C9000 Series Networking Configuration Manual

Apr 3 00:41:03: %PE200-UNIT2-M:CP %IFMGR-5-ASTATE_UP: Changed interface Admin
state to up: Po 257
Apr 3 00:41:03: %PE200-C1048P:2 %IFAGT-5-INSERT_OPTICS_PLUS: Optics SFP+
inserted in slot 2 port 1
Apr 3 00:41:03: %PE200-C1048P:2 %IFAGT-5-UNSUP_OPTICS: Non-qualified optics in
slot 2 port 2
Apr 3 00:41:03: %PE200-UNIT2-M:CP %IFMGR-5-OSTATE_UP: Changed interface state
to up: Te 2/1
Apr 3 00:41:03: %PE200-UNIT2-M:CP %IFMGR-5-OSTATE_UP: Changed interface state
to up: Te 2/2
Apr 3 00:41:23: %PE200-UNIT2-M:CP %IFMGR-5-OSTATE_UP: Changed interface state
to up: Po 257
Apr 3 05:55:02: %PE200-UNIT2-M:CP %EVL-6-EVENT_LOGGING: Start uploading pre-
recorded traps(count:15) to CB
Apr 3 05:55:04: %PE200-UNIT2-M:CP %EVL-6-EVENT_LOGGING: Completed uploading
pre-recorded traps(send count:15, pending traps:0) to CB
Dell#
Dell#show pe brief
--
----------------------------------------------------------
PE-id Status
----------------------------------------------------------
200 online
Dell#show pe 200
Codes: A - Active, I - Inactive
Reason: CTM - Card Type Mismatch, CAM - CAM ACL Mismatch
SVM - Software Version Mismatch, UE - Unknown Error
Offline Reason: UNP - Unit Not Present,
PE-ID assigned: 200
Status: online
System Mac: f8:b1:56:00:02:8a
PE Up Time: 00:01:25
PE Discovery Status: Provisioned PE
User Configured Cascade Ports: Te 0/22(A),Te 0/23(A)
Cascade LAG: Po 458(Up)
------------------------------------------------------------------------
Stack-id Status
------------------------------------------------------------------------
2 online
Dell#
The PE comes online after the auto-synch. To get a dual homing setup, refer to

Supported Features

• Because PE interfaces only support Layer 2 mode, you cannot configure an IP address configuration and
Layer 3 protocol features.
NOTE: The only Layer 3 feature supported on PE ports is L3 VLANs
• A port extender supports the following L2 protocols on PE ports:
• 802.1x
• BPDU guard
• LACP
Port Extenders Information
Stack-size Type
1 C1048P
ICE - IPC CP Error, IRE - IPC RP Error
ISE - IPC Setup Error, CVE - Card Validation Error
Reason
-
--
System-MAC
f8:b1:56:00:02:8a
Type UnitMac
C1048P f8:b1:56:00:02:8a
No. of Ports
52
Setting up Dual Homing.
Port Extenders (PEs) 843