Configure IGMP
Configuring IGMP is a two-step process.
1
Enable multicast routing using the ip multicast-routing command.
2
Enable a multicast routing protocol.
Related Configuration Tasks
•
Viewing IGMP Enabled Interfaces
•
Selecting an IGMP Version
•
Viewing IGMP Groups
•
Adjusting Timers
•
Configuring a Static IGMP Group
•
Preventing a Host from Joining a Group
•
Enabling IGMP Immediate-Leave
•
IGMP Snooping
•
Fast Convergence after MSTP Topology Changes
•
Designating a Multicast Router Interface
Viewing IGMP Enabled Interfaces
Interfaces that are enabled with PIM-SM are automatically enabled with IGMP.
To view IGMP-enabled interfaces, use the following command.
•
View IGMP-enabled interfaces.
EXEC Privilege mode
show ip igmp interface
Example of the show ip igmp interface Command
Dell(conf-if-te-1/0)#show ip igmp interface tengigabitethernet 1/0
TenGigabitEthernet 1/0
Inbound IGMP access group is not set
Internet address is 1.1.1.1/24
IGMP is up on the interface
IGMP query interval is 60 seconds
IGMP querier timeout is 0 seconds
IGMP max query response time is 10 seconds
IGMP last member query response interval is 1000 ms
IGMP immediate-leave is disabled
IGMP activity: 0 joins
IGMP querying router is 1.1.1.1 (this system)
IGMP version is 2
Internet Group Management Protocol (IGMP)
483