Moving A Command From Exec Privilege Mode To Exec Mode; Allowing Access To Configuration Mode Commands; Allowing Access To The Following Modes - Dell C9000 Series Networking Configuration Manual

Moving a Command from EXEC Privilege Mode
to EXEC Mode
To move a command from EXEC Privilege to EXEC mode for a privilege level, use the privilege exec
command from CONFIGURATION mode.
In the command, specify the privilege level of the user or terminal line and specify all keywords in the
command to which you want to allow access.
Allowing Access to CONFIGURATION Mode
Commands
To allow access to CONFIGURATION mode, use the privilege exec level level configure
command from CONFIGURATION mode.
A user that enters CONFIGURATION mode remains at his privilege level and has access to only two
commands, end and exit. You must individually specify each CONFIGURATION mode command you want
to allow access to using the privilege configure level level command. In the command, specify the
privilege level of the user or terminal line and specify all the keywords in the command to which you want to
allow access.

Allowing Access to the Following Modes

This section describes how to allow access to the INTERFACE, LINE, ROUTE-MAP, and ROUTER modes.
Similar to allowing access to CONFIGURATION mode, to allow access to INTERFACE, LINE, ROUTE-MAP, and
ROUTER modes, you must first allow access to the command that enters you into the mode. For example, to
allow a user to enter INTERFACE mode, use the privilege configure level level interface
tengigabitethernet command.
Next, individually identify the INTERFACE, LINE, ROUTE-MAP or ROUTER commands to which you want to
allow access using the privilege {interface | line | route-map | router} level level
command. In the command, specify the privilege level of the user or terminal line and specify all the
keywords in the command to which you want to allow access.
To remove, move or allow access, use the following commands:
• Remove a command from the list of available commands in EXEC mode.
CONFIGURATION mode
privilege exec level level {command ||...|| command}
• Move a command from EXEC Privilege to EXEC mode.
CONFIGURATION mode
privilege exec level level {command ||...|| command}
• Allow access to CONFIGURATION mode.
Switch Management 64