Enable And Disable Iscsi Optimization - Dell C9000 Series Networking Configuration Manual

Target: iqn.2001-05.com.equallogic:0-8a0906-0e70c2002-10a0018426a48c94-iom010
Initiator:
iqn.1991-05.com.microsoft:win-x9l8v27yajg
ISID: 400001370000
VLT PEER2
Session 0:
-----------------------------------------------------------------------------
Target: iqn.2001-05.com.equallogic:0-8a0906-0f60c2002-0360018428d48c94-iom011
iqn.1991-05.com.microsoft:win-x9l8v27yajg
ISID: 400001370000
The following example shows the show iscsi session detailed command.
VLT PEER1
Dell# show iscsi session detailed
Session 0:
--------------------------------------------------------
Target:iqn.2010-11.com.ixia:ixload:iscsi-TG1
Initiator:iqn.2010-11.com.ixia.ixload:initiator-iscsi-2c
Up Time:00:00:01:28(DD:HH:MM:SS)
Time for aging out:00:00:09:34(DD:HH:MM:SS)
ISID:806978696102
Initiator Initiator Target Target Connection
IP Address TCP Port IP Address TCPPort ID
10.10.0.44 33345 10.10.0.101 3260 0
VLT PEER2
Session 0:
--------------------------------------------------------
Target:iqn.2010-11.com.ixia:ixload:iscsi-TG1
Initiator:iqn.2010-11.com.ixia.ixload:initiator-iscsi-2c
Up Time:00:00:01:28(DD:HH:MM:SS)
Time for aging out:00:00:09:34(DD:HH:MM:SS)
ISID:806978696102
Initiator Initiator
IP Address TCP Port
10.10.0.53 33432

Enable and Disable iSCSI Optimization

The following describes enabling and disabling iSCSI optimizaiton.
NOTE: iSCSI monitoring, auto-configuration and auto-detection is enabled by default.
If you enable iSCSI, flow control is automatically enabled on all interfaces. To disable flow control on all
interfaces, use the no flow control rx on tx off command and save the configuration. To disable
iSCSI optimization, which can turn on flow control again on reboot, use the no iscsi enable command
and save the configuration.
When you enable iSCSI on the switch, the following actions occur:
• Link-level flow control is enabled on interfaces where PFC is disabled.
• iSCSI session snooping is enabled.
• iSCSI LLDP monitoring starts to automatically detect EqualLogic arrays.
Target Target
IP Address TCPPort
10.10.0.101 3260
Connection
ID
0
iSCSI Optimization 617