Implementing Frrp; Important Frrp Concepts - Dell C9000 Series Networking Configuration Manual

Hide thumbs Also See for C9000 Series:

Table of Contents

Topology Change RHF: triggered updates; processed at all nodes.

Implementing FRRP

FRRP is media and speed independent.

FRRP is a Dell proprietary protocol that does not interoperate with any other vendor.

You must disable the spanning tree protocol (STP) on both the Primary and Secondary interfaces before

you can enable FRRP.

All ring ports must be Layer 2 ports. This is required for both Master and Transit nodes.

A VLAN configured as a control VLAN for a ring cannot be configured as a control or member VLAN for

any other ring.

The control VLAN is not used to carry any data traffic; it carries only RHFs.

The control VLAN cannot have members that are not ring ports.

If multiple rings share one or more member VLANs, they cannot share any links between them.

Member VLANs across multiple rings are not supported in Master nodes.

Each ring has only one Master node; all others are transit nodes.

The port extender does not support FRRP.

The following table lists some important FRRP concepts.

Each ring has a unique 8-bit ring ID through which the ring is identified (for example,

FRRP 101 and FRRP 202, as shown in the illustration in

Member VLAN Spanning Two Rings Connected by One

Control VLAN

Each ring has a unique Control VLAN through which tagged ring health frames (RHF)

are sent. Control VLANs are used only for sending RHF, and cannot be used for any

other purpose.

Each ring maintains a list of member VLANs. Member VLANs must be consistent across

the entire ring.

Each node has two ports for each ring: Primary and Secondary. The Master node

Primary port generates RHFs. The Master node Secondary port receives the RHFs. On

Transit nodes, there is no distinction between a Primary and Secondary interface when

operating in the Normal state.

Ring Interface

Each interface (port) that is part of the ring maintains one of four states"

Blocking State — Accepts ring protocol packets but blocks data packets. LLDP,

FEFD, or other Layer 2 control packets are accepted. Only the Master node

Secondary port can enter this state.

Pre-Forwarding State — A transition state before moving to the Forward state.

Control traffic is forwarded but data traffic is blocked. The Master node Secondary

Force10 Resilient Ring Protocol (FRRP)