De-Provisioning A Port Extender; Troubleshooting A Port Extender - Dell C9000 Series Networking Configuration Manual

Hide thumbs Also See for C9000 Series:

Table of Contents

PE RELEASE IMAGE INFORMATION :

---------------------------------------------------------------------

C-Series:C1048P

PE BOOT IMAGE INFORMATION :

---------------------------------------------------------------------

PE FPGA IMAGE INFORMATION :

---------------------------------------------------------------------

PE PoE-CONTROLLER IMAGE INFORMATION

---------------------------------------------------------------------

PoE Controller

De-provisioning a Port Extender

To remove the provisioned configuration from a PE, follow one of the de-provisioning procedures in this

To de-provision a PE that is online, shut down its cascade ports and then enter the no pe provision

pe-id command; for example:

Dell(conf)# interface range te 1/0 , te 1/12

Dell(conf-if-range-te-1/0,te-1/12)# shutdown

Dell(conf-if-range-te-1/0,te-1/12)# exit

Dell(conf)# no pe provision 10

To de-provision a PE that is offline, enter the no pe pe-id command; for example:

Dell(conf)# no pe 10

To de-provision all attached PEs, disable the extended-bridge feature on the parent C9010. All attached

PEs (online and offline) are brought down. All PE configurations are removed. For example:

Dell(conf)# no feature extended-bridge

This command will disable the Extended-Bridge feature which will bring down

all the PEs and remove all the PE configs.

Proceed with Extended-Bridge feature disable? [yes/no]:yes

Normally you manage a PE through the C9010 console attached to the parent C9010 switch. However, if a

port extender cannot connect to the C9010, use the following commands from a PE console to troubleshoot

the error condition.

Control Processor

Change current directory

Reset functions

4 2015 09:59:54

Port Extenders (PEs)