Table of Contents
Advertisement
show hardware ip in-acl pe pe-id stack-unit unit—number port-set number
{ counters | <cr> }
•
Display FP entries created for layer 2 for the PE interface(s) to which the egress ACL configurations are
applied.
show hardware mac eg-acl pe pe-id stack-unit unit—number port-set number
{counters | <cr> }
•
Display FP entries created for layer 2 for the PE interface(s) to which the ingress ACL configurations are
applied.
show hardware mac in-acl pe pe-id stack-unit unit—number port-set number
{ counters | <cr> }
•
Display the registers, counters, drops, buffers, and other details about the Triumph and Switch fabric.
show hardware cp-switch {counters | details | drops | port-stats | register |
table-dump}
show hardware sfm sfm-unit-num {buffer {total-buffer | unit unit-num {port |
total-buffer}} | counters | details | drops | port-stats | register | table-
dump}
•
Display hardware system-flow information.
show hardware system-flow stack-unit 0 port-set 0 { counters | }
•
Display the system-flow configuration from a specific port extender hardware component.
Show hardware system-flow pe pe—id stack-unit unit—number port-set number
{ counters | }
NOTE:
You can also clear the system-flow statistics from the specified port extender hardware
component by using the clear hardware system-flow pe pe—id stack-unit unit—number
port-set number { counters | <cr> } command.
•
Display the operational status or the internal ports that are dynamically mapped to a backplane link or
control-plane trunk group that is down.
show hardware {cp | linecard slot—id} bp-link-map
show hardware {cp | linecard slot—id} bp-link-state
show hg-link-bundle—distribution {cp | linecard slot—id} npuUnit unit-number hg-
port-channel channel-num
Troubleshoot a flap or fault condition on a HiGig backplane link by displaying the internal ports that are
mapped to backplane links for control or data traffic and the status of backplane links. In the show
hardware bp-link-state command output, 1 indicates that a backplane link is up; 0 indicates the a
link is down. You can also display the traffic utilization of member interfaces in a HiGig port channel that
transmits control or data traffic from the Control Processor or a line card over the C9000 series
backplane. unit defines the Network Processing unit (NPU) of a HiGig port channel. hg-port-channel
defines the HiGig port-channel number.
NOTE:
In the C9000 series CLI, NPUs are sometimes referred to as units.
Besides the front-end I/O ports on line cards, the C9000 series uses six internal SFM units to transmit the
data between line-card ports.
Debugging and Diagnostics
374
Advertisement
Table of Contents
Troubleshooting
