Return To The Default Cam Configuration - Dell C9000 Series Networking Configuration Manual

| | IN-L3 FIB
| | IN-L3-SysFlow
| | IN-L3-TrcList
| | IN-L3-McastFib |
| | IN-L3-Qos
| | IN-L3-PBR
| | IN-V6 ACL
| | IN-V6 FIB
| | IN-V6-SysFlow
| | IN-V6-McastFib |
| | OUT-L2 ACL
| | OUT-L3 ACL
| | OUT-V6 ACL
1 | 1 | IN-L2 ACL
| | IN-L2 FIB
| | IN-L3 ACL
| | IN-L3 FIB
| | IN-L3-SysFlow
--More--
Return to the Default CAM
Configuration
Return to the default CAM Profile, microcode, IPv4Flow, or Layer 2 ACL configuration using the keyword
default from EXEC Privilege mode or CONFIGURATION mode, as shown in the following example.
Example of the cam-profile default Command
Dell(conf)#cam-profile ?
default Enable default CAM profile
eg-default Enable eg-default CAM profile
ipv4-320k Enable 320K CAM profile
ipv4-egacl-16k Enable CAM profile with 16K IPv4 egress ACL
ipv6-extacl Enable CAM profile with extended ACL
l2-ipv4-inacl Enable CAM profile with 32K L2 and 28K IPv4 ingress ACL
unified-default Enable default unified CAM profile
Dell(conf)#cam-profile default microcode ?
default Enable default microcode
lag-hash-align Enable microcode with LAG hash align
lag-hash-mpls Enable microcode with LAG hash MPLS
Dell(conf)#cam-profile default microcode default
Dell(conf)#cam-ipv4flow ?
default Reset IPv4flow CAM entries to default setting
multicast-fib Set multicast FIB entries
Dell(conf)#cam-l2acl ?
default Reset L2-ACL CAM entries to default setting
system-flow Set system flow entries
| 262141 |
| 2878 |
| 1024 |
9215 |
| 8192 |
| 1024 |
| 0 |
| 0 |
| 0 |
0 |
| 1024 |
| 1024 |
| 0 |
| 320 |
| 32768 |
| 12288 |
| 262141 |
| 2878 |
Content Addressable Memory (CAM)
14 | 262127
45 | 2833
0 | 1024
0 | 9215
0 | 8192
0 | 1024
0 | 0
0 | 0
0 | 0
0 | 0
0 | 1024
0 | 1024
0 | 0
0 | 320
1136 | 31632
2 | 12286
14 | 262127
44 | 2834
264