Rip Configuration Example - Dell C9000 Series Networking Configuration Manual

Hide thumbs Also See for C9000 Series:
Table of Contents

Advertisement

prefix-list-name: the name of an established Prefix list to determine which incoming routes are
modified
offset: the range is from 0 to 16.
interface: the type, slot, and number of an interface.
To view the configuration changes, use the show config command in ROUTER RIP mode.
Debugging RIP
The debug ip rip command enables RIP debugging.
When you enable debugging, you can view information on RIP protocol changes or RIP routes.
To enable RIP debugging, use the following command.
debug ip rip [interface | database | events | trigger]
EXEC privilege mode
Enable debugging of RIP.
Example of the debug ip rip Command
The following example shows the confirmation when you enable the debug function.
Dell#debug ip rip
RIP protocol debug is ON
Dell#
To disable RIP, use the no debug ip rip command.

RIP Configuration Example

The examples in this section show the command sequence to configure RIPv2 on the two routers shown in
the following illustration — Core 2 and Core 3.
The host prompts used in the following example reflect those names. The examples are divided into the
following groups of command sequences:
Configuring RIPv2 on Core 2
Core 2 RIP Output
RIP Configuration on Core 3
Core 3 RIP Output
RIP Configuration Summary
Figure 119. RIP Topology Example
Routing Information Protocol (RIP)
947

Advertisement

Table of Contents
loading

Table of Contents