Dell C9000 Series Networking Configuration Manual page 517

To add a physical interface to a port, use the following commands.
1 Add the interface to a port channel.
INTERFACE PORT-CHANNEL mode
channel-member interface
The interface variable is the physical interface type and slot/port information or port extender (PE)
type and pe-id/unit-number/port-id information.
2 Double check that the interface was added to the port channel.
INTERFACE PORT-CHANNEL mode
show config
Examples of the show interfaces port-channel Commands
To view the port channel's status and channel members in a tabular format, use the show interfaces
port-channel brief command in EXEC Privilege mode, as shown in the following example.
Dell#show int port brief
LAG Mode Status Uptime
1 L2L3 up 00:06:03 Te 1/6 (Up) *
2 L2L3 up 00:06:03 Te 1/7 (Up) *
Dell#
To view a summary of the port channel's status, use the show interfaces port-channel brief
command.
Dell#show interfaces port-channel brief
Codes: L - LACP Port-channel
O - OpenFlow Controller Port-channel
A - Auto Port-channel
I - Internally Lagged
LAG Mode Status
1 L2 up
The following example is for a L2 port channel with port extender interfaces.
Dell#show interface port-channel 111
Port-channel 111 is up, line protocol is up
Created by LACP protocol
Hardware address is 34:17:eb:00:21:91, Current address is 34:17:eb:00:21:91
Interface index is 1258348032
Minimum number of links to bring Port-channel up is 1
Internet address is not set
Mode of IPv4 Address Assignment : NONE
DHCP Client-ID :3417eb002191
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 6000 Mbit
Members in this channel:
255/2/39(U) PeGi 255/3/40(U) PeGi 255/3/45(U)
Ports
Te 1/12 (Up)
Te 1/8 (Up)
Te 1/13 (Up)
Te 1/14 (Up)
Uptime Ports
00:15:36 Te 0/0
Te 0/1
Te 1/12
Te 1/13
PeGi 255/1/36(U) PeGi 255/1/37(U) PeGi 255/2/38(U) PeGi
(Up)
(Up)
(Up)
(Up)
Interfaces 517