Dell C9000 Series Networking Configuration Manual page 904

The following examples show the results of using this command without the command options in the
topology diagram previously shown.
• Display the primary-secondary VLAN mapping. The following example shows the output from the S50V.
show vlan private-vlan mapping
This command is specific to the PVLAN feature.
Examples of Viewing a Private VLANs
The show arp and show vlan commands are revised to display PVLAN data.
The following example shows viewing a private VLAN for a C300 system.
Dell#show vlan private-vlan
Primary Secondary Type
------- --------- --------- ------ --------------
4000
4001
4002
4003
The following example shows viewing a private VLAN for a S50V system.
Dell#show vlan private-vlan
Primary Secondary Type
------- --------- --------- ------ -----------
4000
4001
4003
The following example shows the show vlan private-vlan mapping command.
Dell#show vlan private-vlan mapping
Private Vlan:
Primary : 4000
Isolated : 4003
Community : 4001
NOTE: In the following example, notice the addition of the PVLAN codes – P, I, and C – in the left
column.
The following example shows the VLAN status.
Dell#show vlan
Codes: * - Default VLAN, G - GVRP VLANs, P - Primary, C - Community, I - Isolated
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack
NUM Status Description
* 1 Inactive
100 Inactive
P 200 Inactive primary VLAN in PVLAN
I 201 Inactive isolated VLAN in VLAN 200 T Te 0/21
The following example shows viewing a private VLAN configuration.
!
interface TengigabitEthernet 0/3
no ip address
switchport
switchport mode private-vlan promiscuous
Active Ports
Primary Yes
Community Yes
Community Yes
Isolated Yes
Active Ports
Primary Yes Te 0/3,25
Community Yes Te 0/4-5
Isolated Yes Te 0/6
Te 0/0,23,25
Te 4/0,23
Te 4/24,47
Te 0/24,47
Q Ports
T Te 0/19-20
Private VLANs (PVLAN) 904