Iec 61850 Edition 1 / Edition 2 Mapping - ABB REC670 Applications Manual

Section 1
Introduction
1.5
24
• the character ^ in front of an input/output signal name indicates that the
signal name may be customized using the PCM600 software.
• the character * after an input signal name indicates that the signal must
be connected to another function block in the application configuration
to achieve a valid application configuration.
• Logic diagrams describe the signal logic inside the function block and are
bordered by dashed lines.
• Signals in frames with a shaded area on their right hand side represent
setting parameter signals that are only settable via the PST, ECT or
LHMI.
• If an internal signal path cannot be drawn with a continuous line, the
suffix -int is added to the signal name to indicate where the signal starts
and continues.
• Signal paths that extend beyond the logic diagram and continue in
another diagram have the suffix "-cont."
Illustrations are used as an example and might show other products
than the one the manual describes. The example that is illustrated is
still valid.

IEC 61850 edition 1 / edition 2 mapping

Function block names are used in ACT and PST to identify functions. Respective
function block names of Edition 1 logical nodes and Edition 2 logical nodes are
shown in the table below.
Table 1: IEC 61850 edition 1 / edition 2 mapping
Function block name
AEGPVOC
AGSAL
ALMCALH
ALTIM
ALTMS
ALTRK
BCZPDIF
BCZSPDIF
BCZTPDIF
BDCGAPC
BDZSGAPC
Table continues on next page
Edition 1 logical nodes
AEGGAPC
AGSAL
SECLLN0
ALMCALH
-
-
-
BCZPDIF
BCZSPDIF
BCZTPDIF
SWSGGIO
BBS6LLN0
BDZSGAPC
1MRK 511 401-UEN A
GUID-C5133366-7260-4C47-A975-7DBAB3A33A96 v4
Edition 2 logical nodes
AEGPVOC
AGSAL
ALMCALH
ALTIM
ALTMS
ALTRK
BCZPDIF
BCZSPDIF
BCZTPDIF
BBCSWI
BDCGAPC
LLN0
BDZSGAPC
Bay control REC670 2.2 IEC
Application manual