Upgrading The Gbts Software And Downloading The Data Configuration File (On The Bts Side); Figure 6-2 Usb Port On The Gtmu - Huawei 3900 Series Commissioning Manual

3900 Series Multi-Mode Base Station
Commissioning Guide
6.3.1 Upgrading the GBTS Software and Downloading the Data Configuration File (on the BTS
Side)
The GBTS supports direct software and data configuration file downloading from the USB disk.
After the downloading, the GBTS automatically activates the software, and then resets.
6.3.2 Upgrading the NodeB Software and Downloading the Data Configuration File (on the
NodeB Side)
The NodeB supports direct software and data configuration file downloading from the USB disk.
After the downloading, the NodeB automatically activates the software, and then resets.
6.3.3 Upgrading the eNodeB Software and Downloading the Data Configuration File (on the
eNodeB Side)
This section describes how to download and activate the eNodeB software and data configuration
file through the USB storage device. The eNodeB automatically downloads the software and
data configuration file from the USB storage device, and then activates them. The software and
data configuration take effect after the eNodeB resets.
6.3.1 Upgrading the GBTS Software and Downloading the Data
Configuration File (on the BTS Side)
The GBTS supports direct software and data configuration file downloading from the USB disk.
After the downloading, the GBTS automatically activates the software, and then resets.
Context
l
l
l
l
Procedure
Step 1 Insert the USB disk to the USB port on the GTMU, as shown in

Figure 6-2 USB port on the GTMU

Issue 02 (2010-07-30)
Software upgrade by using a USB disk is supported from GSM BTS3000
V100R009C00SPC058.
Transmission configuration by using a USB disk is supported from GSM BTS3000
V100R009SPC072.
Within 3 minutes after GBTS started, GBTS cannot perform the USB upgrade or
configuration. During the 3-minute period, GBTS is trying to connect with BSC and is not
using the date files in the USB disk. After the GBTS started for 3 minutes, it is sure that
the GBTS cannot connect to the BSC, and the GBTS starts the configuration by
downloading the board software according to the pre-configured script with the data
configuration files on USB.
If the GBTS is not connected with BSC, only the transmission data can be configured with
the USB disk, other data will not be configured. Also, the GBTS only upgrades the software
on GTMU, and will not upgrade the software on other boards(For example, DRFU, MRFU,
UTRP). After the GBTS connects BSC, the GBTS finishs the data configuration, and
upgrades the software on other boards except GTMU.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Commissioning the MBTS by Using USB and M2000
Figure 6-2.
6-13