Procedure For Commissioning The Mbts Using Local Maintenance Terminal And M2000 - Huawei 3900 Series Commissioning Manual

3900 Series Multi-Mode Base Station
Commissioning Guide
7.1 Procedure for Commissioning the MBTS Using Local
Maintenance Terminal and M2000
At the local end of the MBTS, you can use local maintenance terminal to upgrade MBTS software
and configure MBTS data and to facilitate the establishment of MBTS OM at the MBTS. You
can also check whether the MBTS hardware status is normal according to the board status and
LED status, to locate and rectify faults (if any) in time. At the M2000, you can check the MBTS
operating status.
Prerequisite
Before you commission the MBTS, the MBTS, RNC, and M2000 must meet following
requirements:
l
l
l
In addition, the following requirements must be met:
l
l
l
Commissioning Flowchart
Figure 7-1
and M2000.
Issue 02 (2010-07-30)
The MBTS hardware such as the cabinets, cables, antenna system, and auxiliary devices,
is installed and passes the installation check. The MBTS is powered on and passes the
power-on check.
The controller hardware is installed and commissioned, and the system works properly.
The negotiation data of the MBTS to be commissioned is configured and recorded.
The M2000 is commissioned, it is connected to the corresponding controller, and the
configuration synchronization is completed.
A portable computer used for local commissioning is ready.
The portable computer is installed with local maintenance terminal mapping with the mode
of the base station to be commissioned.
The target version software package and data configuration file of the base station to be
commissioned are ready and saved on the portable computer.
shows the procedure for commissioning the MBTS using local maintenance terminal
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Commissioning the MBTS by Using Local Maintenance
Terminal and M2000
7-3