Figure 6-4 Inserting The Usb Storage Device; Table 6-6 Led Status - Huawei 3900 Series Commissioning Manual

3900 Series Multi-Mode Base Station
Commissioning Guide

Figure 6-4 Inserting the USB storage device

Step 2 Check whether the eNodeB is powered on.
If ...
The eNodeB is not powered on
The eNodeB is powered on
Step 3 After the eNodeB is started, it automatically upgrades the eNodeB software and data
configuration.
If the download or activation fails, reinsert or replace the USB storage device, power off the
eNodeB and power it on again, and then perform the commissioning through the USB storage
device. If the download or activation still fails, perform the local eNodeB commissioning on the
LMT.
downloaded and activated through the USB storage device.

Table 6-6 LED status

Automatically detecting
the USB storage device
Downloading the software
from the USB storage
device
Issue 02 (2010-07-30)
Table 6-6 lists the status of LEDs when the software and data configuration file are
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Commissioning the MBTS by Using USB and M2000
Then ...
Power on the eNodeB. The eNodeB
automatically detects the USB storage device
during startup.
Power off the eNodeB and power it on again.
The eNodeB automatically detects the USB
storage device during startup.
Status of the LED on
the USB Storage
Device
On
Blinking
Status of the RUN LED on the
LMPT
Blinking (on for 1s and off for 1s)
Blinking (on for 0.125s and off for
0.125s)
6-19