Replacing The Main Cooling Fan, Frames Size R6 - ABB ACS560 Hardware Manual

WARNING! Obey the instructions in chapter
Ignoring the instructions can cause physical injury or death, or damage to the
equipment.
1. Stop the drive and disconnect it from the power line. Wait for 5 minutes and then
make sure by measuring that there is no voltage. See section
electrical work on page
1. Stop the drive and disconnect it from the power line. Wait for 5 minutes and then make
sure by measuring that there is no voltage. See section
2. Lift the fan assembly upwards from the front edge (2a) and remove the assembly
work (page 13) before you start the work.
(2b).
2. Lift the fan assembly upwards from the front edge (2a) and remove the assembly (2b).
3. Unplug fan power supply wires from the drive.
3. Unplug fan power supply wires from the drive.
4. Install the new fan assembly in reverse order.
4. Install the new fan assembly in reverse order.
0.05acres
￭ Replacing the main cooling fan, frames size R6...R8
WARNING!
Obey the instructions in chapter
instructions can cause physical injury or death, or damage to the equipment.
1. Stop the drive and disconnect it from the power line. Wait for 5 minutes and then make
sure by measuring that there is no voltage. See section
work (page 13) before you start the work.
2. Remove the two mounting screws of the fan mounting plate at the bottom of the drive.
3. Pull the fan mounting plate down from the side edge.
4. Unplug fan power supply wires from the drive.
5. Lift the fan mounting plate off.
6. Remove the fan from the mounting plate.
14 before you start the work.
Safety instructions (page
Safety instructions
Maintenance and hardware diagnostics 101
Precautions before
Precautions before electrical
2b
11). Ignoring the
Precautions before electrical
on page 11.