Connection Procedure, Frames R5 - ABB ACS560 Hardware Manual

11. Install the grounding shelf for the control cables (included with the mounting
Finalization
screws in a plastic bag in the delivery) onto the grounding shelf for the power
cables.
11. Install the grounding shelf for the control cables (included with the mounting
screws in a plastic bag in the delivery) onto the grounding shelf for the power
cables.
12. Ground the motor cable shield at the motor end. For minimum radio frequency
12. Ground the motor cable shield at the motor end. For minimum radio frequency
interference, ground the motor cable shield 360 degrees at the lead-through of
interference, ground the motor cable shield 360 degrees at the lead-through of the motor
the motor terminal box.
terminal box
12. Ground the motor cable shield at the motor end. For minimum radio frequency
8
interference, ground the motor cable shield 360 degrees at the lead-through of
the motor terminal box.
8
￭ Connection procedure, frames R5...R8
WARNING!
If the drive will be connected on an IT (ungrounded) system, make sure you have
disconnected the EMC filter and ground-to-phase varistor. See
compatibility with IT (ungrounded) and corner-grounded TN systems (page
If the drive will be connected on a corner-grounded TN system, make sure you
have disconnected the EMC filter. See section
1. Attach the residual voltage warning sticker next to the control board.
2. Remove the side plates of the cable box as follows:
• Remove the retaining screws.
• Slide the walls out.
8
8
EMC filter (page
Electrical installation 75
Checking the
63).
63).