Input Power Cable - ABB ACS560 Hardware Manual

Motor cable
Motor cable
2. Prepare the ends of the cable as illustrated in the figure. Two different motor cable
2. Prepare the ends of the cable as illustrated in the figure. Two different motor cable
types are shown in the figures (2a.and 2b).
types are shown in the figures (2a.and 2b).
Note: The bare shield will be grounded 360 degrees.
Note: The bare shield will be grounded 360 degrees.
2a
2a
PE
PE
2
b
2
b
PE
PE
3. Connect the motor cable as follows:
• Ground the shield 360 degrees by tightening the clamp of the power cable
3. Connect the motor cable as follows:
grounding shelf onto the stripped part of the cable (3a).
• Ground the shield 360 degrees by tightening the clamp of the power cable grounding
• Connect the twisted shield of the cable to the grounding terminal (3b).
shelf onto the stripped part of the cable (3a).
• Connect the phase conductors of the cable to the terminals of T1/U, T2/V and
• Connect the twisted shield of the cable to the grounding terminal (3b).
T3/W.
• Connect the phase conductors of the cable to the terminals of T1/U, T2/V and T3/W.
3c
3a
• Tighten the screws to the torque given below.
• Tighten the screws to the torque given below.
Frame size
Frame size
T1/U. T2/V. T3/W
T1/U. T2/V. T3/W

Input power cable

4. Prepare the ends of the cable as illustrated in the figure.
Input power cable
Note: The bare shield will be grounded 360 degrees. Mark the pigtail made from
4. Prepare the ends of the cable as illustrated in the figure.
the shield as a PE conductor with yellow-and-green color.
Note:
PE
PE
3b
R0...R1
N·m
0.5...0.6
Electrical installation 69
Electrical installation 79
R2
lbf·ft R0...R1 N·m lbf·ft
0.4 1.2...1.5 0.9...1.1
N·m lbf·ft
0.5...0.6 0.4 1.2...1.5
R2
N·m lbf·ft
0.9...1.1