Option Slot 1 (Fieldbus Adapter Modules); Wiring The Modules; Reinstalling Covers; Reinstalling Cover, Frames Size R0 - ABB ACS560 Hardware Manual

1. Remove the front cover(s) if not already removed. See
R0...R2 (page 68),
procedure, frames R5...R8 (page
2. Put the module carefully into its position on the control board.
3. Tighten the mounting screw.
Note:
The screw grounds the module firmly. It is necessary for fulfilling the EMC requirements
and for proper operation of the module.

Option slot 1 (fieldbus adapter modules)

1. Position the module carefully on the control board.
2. Tighten the mounting screw (CHASSIS).
Note:
The screw tightens the connections and grounds the module. It is necessary for fulfilling
the EMC requirements and for proper operation of the module.
￭

Wiring the modules

See the appropriate optional module manual for specific installation and wiring instructions.

Reinstalling covers

Reinstalling covers
Reinstalling cover, frames size R0...R2
￭ Reinstalling cover, frames size R0...R2
1. Reinstall the cover.
1. Reinstall the cover.
2. Tighten the retaining screw at the bottom with a screwdriver.
2. Tighten the retaining screw at the bottom with a screwdriver.
Connection procedure, frames R3...R4 (page 71)
75).
1
2
Electrical installation 91
Connection procedure, frames
or Connection
Electrical installation 103