General Safety In Operation - ABB ACS560 Hardware Manual

16 Safety instructions

General safety in operation

These instructions are for all personnel that operate the drive.
WARNING!
Obey these instructions. If you ignore them, injury ordeath, or damage to the
equipment can occur.
• Do not control the motor with the disconnector at the drive power supply; instead, use
the control panel start and stop keys or commands through the I/O terminals of the
drive.
• Give a stop command to the drive before you reset a fault. If you have an external source
for the start command and the start is on, the drive will start immediately after the fault
reset, unless you configure the drive for pulse start. See the firmware manual.
• Before you activate automatic fault reset functions of the drive control program, make
sure that no dangerous situations can occur. These functions reset the drive automatically
and continue operation after a fault.
Note:
When the control location is not set to Local, the stop key on the control panel will not stop
the drive.When the drive is not in the Hand mode, the Off key on the control panel will not
stop the drive.