Connecting As A Ppp Client - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Figure 157: Trigger Action Form
1. Perform Button
2. On the AT Command form, configure the following parameter(s) as required:
Parameter
command
On the Trigger Action form, click Perform to run the command.
3.
Section 3.23.10

Connecting as a PPP Client

To connect or disconnect from a cellular network as a PPP client, do the following:
Change the mode to Edit Private or Edit Exclusive.
1.
2. Make sure the cellular modem interface has been configured. For more information, refer to
"Configuring a Cellular Modem
3. Make sure an appropriate cellular modem profile has been configured. For more information, refer to
Section 5.13, "Managing Cellular Modem
4. Make sure an account has been activated with a service provider for the modem type (e.g. HSPA+, Edge or
CDMA).
5. Make sure antennas are properly connected to the cellular modem module before initiating the connection.
6. For HSPA+ and Edge modems, insert a SIM card into the cellular modem module.
7. For CDMA modems, activate the modem either manually or over-the-air. For more information, refer to
Section 3.23.7, "Activating a Cellular Modem
8. Verify the network status for the appropriate cellular modem type. For more information, refer to:
• Section 3.23.4, "Viewing the HSPA Network Status for Cellular Modems"
• Section 3.23.5, "Viewing the CDMA Network Status for Cellular Modems"
Navigate to interface » cellmodem » {interface} » {hspa/edge/cdma}, where {interface} is the cellular
9.
modem.
10. Click the + symbol in the menu next to ppp-client. The Profile form appears.
Connecting as a PPP Client
Description
The Modem AT command to be executed. Note: The command must begin with the
prefix 'AT'
Interface".
Profiles".
Account".
Chapter 3
Device Management
1
Section 3.23.6,
151