Connecting Through The Network - Siemens RX1500 User Manual

Chapter 2
Using ROX II
Figure 1: MGMT Port
2. By default, the RUGGEDCOM RX1500 has a different IP address and subnet configured for two types of IP
interfaces, both of which are mapped to one or more physical ports:
Port
MGMT
All other Ethernet ports
For example, if the device is connected via the MGMT port, configure the computer's Ethernet port with
an IP address in the range of 192.168.1.3 to 192.168.1.254. Connect to the device using the IP address
192.168.1.2, the address of the MGMT interface.
3. Launch the SSH client on the computer and connect to admin@{ipaddress}, where {ipaddress} is the IP
address for the MGMT port. The login prompt appears:
Using username "admin".
admin@192.168.0.2's password:
4. Log in to ROX II. For more information about logging in to ROX II, refer to
Section 2.1.2

Connecting Through the Network

To connect to ROX II through the network, do the following:
1. On the computer being used to connect to the device, configure the Ethernet port to use an IP address falling
within the subnet of the device.
By default, the RUGGEDCOM RX1500 has a different IP address and subnet configured for two types of IP
interfaces, both of which are mapped to one or more physical ports:
Port
MGMT
All other Ethernet ports
For example, if the device is connected via the MGMT port, configure the computer's Ethernet port with
an IP address in the range of 192.168.1.3 to 192.168.1.254. Connect to the device using the IP address
192.168.1.2, the address of the MGMT interface.
14
IP Address/Mask
192.168.1.2/24
192.168.0.2/24
Section 2.3, "Logging
IP Address/Mask
192.168.1.2/24
192.168.0.2/24
Connecting Through the Network
RUGGEDCOM ROX II
User Guide
In".