Configuring A Routing Interface - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Section 5.20.11.2

Configuring a Routing Interface

To configure a routing interface for a RIP network, do the following:
NOTE
OSPF regards router interfaces as either passive or active, sending OSPF messages on active
interfaces and ignoring passive interfaces.
1. Change the mode to Edit Private or Edit Exclusive.
Navigate to routing » dynamic » rip » interface » {name}, where {name} is the name of the interface. The
2.
Authentication and Interface Parameters forms appear.
Figure 580: Authentication Form
1. Mode List 2. Key Chain List
Figure 581: Interface Parameters Form
1. Passive Interface Check Box
3. On the Authentication form, configure the following parameter(s) as required:
Configuring a Routing Interface
1
2
3
3. String Box
1
2
3
4
2. Receive Version List 3. Send Version List 4. Split Horizon List
Chapter 5
Setup and Configuration
505