Managing Remote Server Selectors; Viewing A List Of Remote Server Selectors; Adding A Remote Server Selector - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
5. Click Exit Transaction or continue making changes.
Section 3.9.5

Managing Remote Server Selectors

Remote server selectors filter the information sent to specific servers.
The following sections describe how to configure and manage remote server selectors:
• Section 3.9.5.1, "Viewing a List of Remote Server Selectors"
• Section 3.9.5.2, "Adding a Remote Server Selector"
• Section 3.9.5.3, "Deleting a Remote Server Selector"
Section 3.9.5.1

Viewing a List of Remote Server Selectors

To view a list of remote server selectors, navigate to admin » logging » server » {address} » selector, where
{address} is the IP address of the remote server. If remote server selectors have been configured, the Remote
Server Selector table appears.
Figure 45: Remote Server Selector Table
If no remote server selectors have been configured, add selectors as needed. For more information, refer to
Section 3.9.5.2, "Adding a Remote Server
Section 3.9.5.2

Adding a Remote Server Selector

To add a remote server selector, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to admin » logging » server » {address} » selector, where {address} is the IP address of the
remote server.
3. Click <Add selector>. The Key Settings form appears.
Managing Remote Server Selectors
Selector".
Chapter 3
Device Management
53